Buy ASTM D Standard Specification for Polycarbonate (PC) Unfilled and Reinforced Material from SAI Global. ASTM D Standard Classification System and Basis for Specification for Polycarbonate (PC) Unfilled and Reinforced Material. In as much as Palram Americas, Inc. has no control over the use to which others may put the material, it does not guarantee that the same results as those.
|Published (Last):||2 November 2007|
|PDF File Size:||18.83 Mb|
|ePub File Size:||8.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
Some of these compositions may also find use for compression molding or application from solution. This standard does not purport to address all safety concerns, if any, associated with its use. This classification system allows for the use of recycled materials provided that all specification requirements are met.
Standard Specification for Polycarbonate (PC) Unfilled and Reinforced Material
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Other requirements necessary for identifying particular characteristics important to specific applications are normally specified by using the suffixes in accordance with Section 5.
This specification covers unfilled and reinforced polycarbonate and polycarbonate copolymer materials suitable for injection molding, blow molding, and extrusion. This abstract is a brief summary of the referenced standard.
ASTM D3935 – 15
ASTM d335 not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Different tests shall be conducted in order to determine the following properties of polymer materials: It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use. Unfilled polycarbonate materials are classified into groups according to their composition.
Lexan Sheet | Polycarbonate Plastic | High impact Plastic
Link to Active This link will always route to the current Active version of the standard. Material selection should be made by those having expertise in the plastic field only after consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs astj, and the inherent properties of the material other than those covered in this standard.
These groups r3935 subdivided into classes which are Class 0, Class 1, Class 2, Class 3, and Class 4 and these classes can be further be subdivided into grades which are Grade 1, Grade 2, Grade 3, Grade 4, Grade 5, Grade 6, Grade 7 and Grade 0. No other units of measurement are included in this standard. Izod impact strength, flexural modulus, tensile strength, and deflection temperature.
Historical Version s – view previous versions of standard. It is not intended for the selection of materials.